A new fan or light fixture looks simple until you find there's no fan rated box, the wiring is decades old or the switch doesn't do what it should. Professional ceiling fan installation and lighting work from Sherrill Co. means the fan is hung solid, balanced and quiet, and every light is wired right the first time.
We handle ceiling fans, light fixtures, chandeliers, recessed lighting, LED conversions and replacement motors for bath fans, vent fans, pool pumps and spas. No job is too small to call about.
Whether it's one ceiling fan installation or new lighting for every room, we follow the same steps so the fixture is safe, solid and looks right when we leave.
One fan or a whole house of fixtures? Existing wiring or a brand new spot? A photo of the ceiling and the fixture box helps a lot.
We confirm the ceiling box is fan rated, add bracing when needed, and check the wiring and the switch before anything goes up.
New locations, added switches, dimmers or a separate fan and light control get wired properly, with as little ceiling damage as possible.
We assemble and hang the fan or fixture, balance the blades, set the downrod height and connect the remote or wall control.
We test every speed, light and switch, haul off the boxes, and call a few days later to make sure everything works the way you want.
A fan that's too small barely moves the air, and one that's too big feels like a helicopter. The right size depends on the room, and the right mounting depends on the ceiling height.
Enter your room and ceiling height and the guide will suggest a blade span and downrod length. We check both again during every ceiling fan installation.
| Up to 75 sq ft | 29 to 36 in |
|---|---|
| 76 to 144 sq ft | 36 to 44 in |
| 145 to 225 sq ft | 44 to 50 in |
| 226 to 400 sq ft | 50 to 60 in |
| Over 400 sq ft | 60 in or two fans |
Ceiling fan size guide
Suggested blade span
44 to 50 in
168 square feet
Suggested mounting
6 in rod
Blades about 8 ft from the floor
Tip: blades should sit at least 7 feet above the floor, and about 8 to 9 feet is ideal for airflow.
General guidance based on common industry sizing. Fan models vary, so check the manufacturer's recommendations too.
From ceiling fan installation to recessed lighting and worn out motors, these are the four kinds of lighting work Columbus homeowners call us for most.
New fans, replacement fans and fans in rooms that never had one. We install fan rated boxes, bracing, downrods for high ceilings and remote or wall controls.
Kitchen and dining fixtures, pendants, vanity lights, entry chandeliers and outdoor lights, hung level and wired to the right switch or dimmer.
Recessed can lights, slim LED wafer lights, under cabinet lighting and LED conversions for old fluorescent fixtures, like the kitchen retrofit one of our customers wrote about.
Bath exhaust fans, vent fans, attic fans and the motors on pool pumps and spas wear out. We replace them and make sure they are wired and vented the right way.
Some homeowners handle a simple swap themselves. It's time to call a licensed electrician when any of these sound familiar.
Not sure? Send a photo of the ceiling box and your new fixture to service@sherrillcompany.com and we'll tell you what it needs.
Every ceiling is different, so we price the job after we know what's there. These are the things that move the number up or down.
Replacement or new locationSwapping a fixture on an existing box is quicker than running new wire to a new spot.
Box and bracingInstalling a fan rated box and bracing adds a little time but is essential for safety.
Ceiling height and accessHigh, vaulted or hard to reach ceilings and attics without access take more setup.
ControlsDimmers, separate fan and light switches, and remote or smart controls add parts and wiring.
Number of fixturesDoing several fans or lights on one visit is usually more efficient than scheduling them one by one.
"JR and his team rewired my boat dock including the installation of new lights. They did a very professional job on all aspects of this boat dock work. They also installed some new lights in the kitchen and converted two old fluorescent light fixtures for use with new LED bulbs. We are very happy with their work and will ask for JR and these guys by name on any future electrical work we might need."
Dave StevensonGoogle review, lighting and dock work
Offices, shops and other businesses in Columbus and Phenix City call us for LED retrofits, new fixtures and brighter, cheaper to run lighting inside and out.
Commercial electrical servicesWhat homeowners ask us most about fans, fixtures and lighting. A photo of your ceiling box and the new fixture helps us answer quickly.
Ask about your project(706) 569-7518
Replacing a fan on an existing fan rated box is the simplest job. Installing a fan where there was only a light, adding bracing, running new wire to a new location, or working on a high or vaulted ceiling adds time and materials. We give you a clear price once we know what the ceiling and wiring look like, and a photo usually tells us most of it.
Yes. We run new wiring from a nearby circuit, install a fan rated box with proper bracing and add a wall switch or remote control. We plan the route through the attic or walls to keep ceiling damage to a minimum.
No. A ceiling fan needs a box that is rated for fan support and anchored to the framing. A standard light box can work loose from the weight and motion of a fan over time. We check the box during every ceiling fan installation and replace or brace it when needed.
As a general guide, rooms up to 75 square feet take a 29 to 36 inch fan, 76 to 144 square feet take 36 to 44 inches, 145 to 225 square feet take 44 to 50 inches, and 226 to 400 square feet take 50 to 60 inches. Use the size guide on this page for your room and ceiling height.
Yes. We either replace the old fixture with a new LED fixture or rewire it to run LED tubes without the old ballast. It is brighter, uses less power and ends the buzzing and flicker. One of our customers had two kitchen fixtures converted this way along with new lights.
Yes. Slim LED wafer lights and remodel style cans are made for existing ceilings, and we plan the layout and wiring so the lights are evenly spaced and controlled by the right switch or dimmer.
Yes. We replace noisy or dead bath exhaust fans, and we can upgrade to a quieter model or one with a light or humidity sensor. We also make sure the fan is vented properly and not just blowing into the attic.
Yes. We are licensed in Georgia and Alabama and handle ceiling fan installation and lighting in Columbus, Fortson and Cataula as well as Phenix City, Smiths Station, Opelika and Auburn. See our service area for the full list.
